Devilbiss might look like a tough name to you, and these air compressors are a pretty great definition of durability. You don’t have to worry much if you are using these air compressors as they can deal with stress and heavy-duty applications pretty greatly. These Devilbiss air compressors have some of the old technologies, but that allows you to have peace of mind as well, that the mechanical components don’t break or tend to go bad very often.
In addition to all that, there are tons of other great options and features that you get on these air compressors from Devilbiss. These air compressors are mostly used for commercial or small-scale industrial applications. These Devilbiss air compressors have some common problems that you will have to deal with. A few of these common problems and their solutions are:
Devilbiss Air Compressor Problems
1) Not Turning On
While the motor and mechanical parts on these air compressors are pretty durable, and they work out well under tough situations, the same cannot be said for the electric parts. There are certain issues and flaws in the wiring that are functional, but they can cause you to face different problems with the utility of these air compressors.
First of all, you will need to ensure that you are using a voltage stabilizer with these air compressors. Not only the low voltage will make the air compressor to stop turning on, there is also a possibility that voltage fluctuation might cause some permanent damage to the circuit, circuit breakers, and sometimes can blow the fuse for you. Voltage fluctuations can also cause a short circuit in the wiring and the current flow will be affected due to this. You will need to make sure that the voltage stabilizer is installed at all times with your Devilbiss Air Compressor.
If you have not been using it before, there are a few other things that you will need to check. You will need to ensure that you check on all the fuses and if you find any of them to be blown, you will have to replace them in order to get it working again.
2) Oil reduction
Oil reduction is a concept that is newer for this generation, but all those who have used those old-school motors have dealt with this issue their entire youth on those classics. The oil tends to burn at times and that can cause the motor lubricant to be reduced than the level it is needed to be at. This needs to be checked, and if there is excessive smoke coming out of the exhaust, this can clearly be the problem with your Devilbiss air compressor.
You will need to keep topping up the oil regularly and make sure to check on the oil levels at all times. If you feel like the oil is being reduced more than it should, you will have to get the gasket on the motor checked with some technician and that will help you out in solving the problem for good.
3) Excessive Noise
You can also be facing some problems with the noise on these Devilbiss air compressors. There are two types of noises that you might have to deal with.
The first one being the rattling sound or the sounds coming from the motor. These sounds are usually caused in case your oil needs to be changed, you might have some loose nuts and bolts, or if the air compressor is not on the flat surface. You need to place it on a flat surface, change the oil regularly and tighten all the nuts and bolts on your air compressor. This will be solving the problem for good and all the noise will be gone.
Secondly, you might be getting some strange squeaking sounds on the belt. If you are getting these sounds on your belt, you will have to check on the belt first and make sure that it is not hardened due to moisture or usage over time. You will also need to check on the pulley and bearing and make sure that the bearing is not stuck. You will need to put some oil inside the bearing to get it going. If it is stuck, a bearing replacement will get the job done for you.
